UK PSTN number to IAX termination

rgower :

Sadly outbound IAX isn't available... yet?

Nope - afraid it's only sip at the moment but it seems to work fine in Asterisk for me and many other users.

Although, IAX does go through NAT/firewalls easier

--ian

Is there any particular reason for not allowing IAX2 both ways? Dean and/or Tj?

Sanyi

Add me to the list, I'm using asterisk as well, so I will also use it as soon as it is available.

Regards,

Marc

Been available for several months now Marc - check your control panel and request a number.

Dean

Oh, yes I see, I was a little confused and thought this was about the Outbound Service.

Regards,

Marc

Ah, ok. Outbound on IAX is a little tricky for us at the moment due to the way the Cisco switches are configured.

Perhaps not impossible for the future, but we can't do it just at the moment without running an Asterisk server. That means additional bandwidth cost and for obvious reasons (keeping the outbound pot maintained) we really need to keep our overhead as low as possible.

Dean

hi,

I'd like iax support can you enable it for me too please

Hello tjadick,

"Please send me a private message (site or mail) with the number you have on your account, that you would like to have forwarded over IAX togther with an IAX URI you want as destination.

Regards

Tj"

That was one of your message to a user, but my own case is the reverse: I need a uri/iax call forwarding service, whereby i can be assigned a uri/iax address to my mobile number. I have a DID with voxbone already, I will register the uri/iax address with voxbone and map my DID to the uri address you will assign to my mobile. If you do not ofer this service please refer me asap. Call forwarding is cheaper for me with this service. I have used it with Euroaix in the past. Please, email me seperately : cruz [!at] platinumplc.net (replace the [!at] with a @)

thanks

cwm